| APPLICATION METHODS |
| |
RS-2030 can be applied by either roller, brush or spray.
Best results can be obtained with airless spray equipment.
The following table provides basic airless spray equipment information.
| Spray Equipment: | Airless |
| Orifice size: | 0.019 |
| Fluid Pressure (PSI): | 1500-2000 |
| Fluid hose size: | 3/8"-1/2" |
See Inland Application Bulletins for additional information.
|
| PRODUCT TEMPERATURE |
| |
For best spray application, RS-2030 should be at a minimum of
60° F. The product should not be allowed to freeze.
|
| APPLICATION TEMPERATURE |
| |
For best results, the temperature of the ambient air and the substrate
should be within a range of 40°-110°F.
|
| SURFACE PREPARATION |
| |
The surface must be clean, dry and free of dirt, oil or other
contaminants prior to application. This is normally best achieved by
power washing the surface. Spray nozzle should be held an adequate
distance from the surface to prevent roof damage. Make sure all
drains are free of debris or blockage. Allow roof to dry thoroughly
before any product applications.
|
| HANDLING |
| |
Do not get into eyes. Avoid prolonged or repeated skin contact.
Follow good personal and industrial hygiene procedures.
|
| STORAGE |
| |
Store in a cool, dry, well-ventilated area. Avoid freezing.
|
| RS-2030 TECHNICAL DETAILS |
| |
| Colors: | Clear |
| Coverage Rate: | 250 sq. ft/gal |
| Wet Mil Thickness: | 6-8 mils |
| Dry Mil Thickness: | 3-4 mils |
| Weight: | 8.5 lb./gal. |
| Solids (% by Weight): | 44.1 ± 1% |
| Solids (% by Volume): | 42.8 ± 1% |
| Dry to Touch: | 1-3 hours |
| Reduction: | None |
| Flash Point: | None. |
| Viscosity | 1300-1500cps |
|
The specifications, properties and performance of materials described
herein are based on information believed to be reliable.
Unless otherwise expressly provided in written contract, the products
discussed are sold without conditions or warranties, expressed or implied.
Product specifications are subject to change without notice.
