[Application Methods] [Temperatures] [Surface Prep] [Handling & Storage] [Details]
| APPLICATION METHODS |
| |
CR-2100 can be applied by either brush or roller.
|
| PRODUCT TEMPERATURE |
| |
The product temperature should be at a minimum of 50° F.
|
| APPLICATION TEMPERATURE |
| |
For best results, the temperature of the ambient air and the substrate
should be within a range of 40°-110°F.
|
| SURFACE PREPARATION |
| |
The surface must be free of any moisture, rust scale or soil. Remove any
loose material from cracks or seams with a wire brush or scraper. Oil and
grease should also be removed. In many cases water blast will be sufficient
to prepare the surface.
|
| CR-2100 HANDLING & STORAGE |
| |
CR-2100 contains a blend of solvents which is considered
combustible by D.O.T. and O.S.H.A. standards. It should be used and
stored away from flames, in a well-ventilated atmosphere. Avoid prolonged
breathing of vapors and prevent contact with eyes. In case of eye contact,
flush with water for 15 minutes and call a physician. Read all label
information and precautions before using.
|
| CR-2100 TECHNICAL DETAILS |
| |
| Colors: | Clear |
| Type of Resin: | Synthetic Rubber |
| Coverage Rate: | 100 sq ft/gal |
| Wet Mil Thickness: | 10-12 mils |
| Dry Mil Thickness: | 4-5 mils |
| Specific Gravity: | 0.864 |
| Weight: | 7.2 lb/gal |
| Solids (% by Weight): | 37.1 ± 1% |
| Solids (% by Volume): | 32.4 ± 1% |
| Drying Time: | 1-3 hours |
| Reduction: | None |
| Flash Point: | 101° F. |
| Elongation (ASTM-D-412): | 400% |
| Tensile Strength (ASTM-D-412): | 1520 PSI |
Water Vapor Transmission
Permeance (ASTM-E-96): | 0.166 perms @ 10 mils |
|
The specifications, properties and performance of materials described herein are based on information believed to be reliable. Product specifications are subject to change without notice.CR-2100 Overview
Printable CR-2100 Spec Sheet (PDF)
CR-2100 MSDS
