Inland Coatings - Modified & BUR 5 Year Limited Product Warranty Requirements

Modified & BUR 5 Year Limited Product Warranty Requirements

The following links and information provide guidance in proper application methods and document submittal procedures for issuance of the "Inland Modified & BUR Roof 5 Year Limited Product Warranty". This warranty is not applicable to residential installations or any installation under 100 squares in size unless pre-approved in writing by Inland.

The "Attachment A" form should be used for pre-approval prior to commencing any project under 100 squares.

Attachment A (pdf)

Preliminary Project Review. Immediately after contract award, a complete and accurate Bid Report must be submitted to the Inland Warranty Department for approval. This should include pages 1, 2 and 3 of the Inland Project Profile, with a drawing of the roof and the following pictures with detailed descriptions:

Distant shot of entire building.
Roof height shot of overall project.
Close-up of horizontal and vertical seams.
Any unusual flashing or problem areas.

Project Profile (pdf)

A project approval letter must be received from Inland prior to beginning a Warranted project for Modified Bit & BUR substrates. All Project Review pictures and documents should be sent to the following address:

Inland Coatings Corporation
Warranty Department
P.O. Box 247
26259 Hwy 6
Adel, IA 50003

For proper application procedures, please refer to Inland Specification #IMB350M-6 or #IMB355M, in addition to the "General Requirements". We have also provided a link for basic Spray Equipment Recommendations.

IMB350M-6 (SEBS solvent-based) Specification (pdf)
IMB355M (RC 3000 water-based) Specification (pdf)
General Requirements (pdf)
Spray Equipment Recommendations (pdf)
Round Penetration Detail Drawing (pdf) (Viewable JPG version)
Ridge Cap Detail Drawing (pdf) (Viewable JPG version)

At project completion, please refer to the "Warranty Checklist". This will ensure that all necessary information and documents are properly submitted.

Warranty Checklist (pdf)

The following Warranty and Project Forms should be completed and submitted to the Inland Coating Warranty Department. The product warranty form must be the original, signed copy.

Modified & BUR 5 Year Limited Product Warranty (pdf)
Project Profile (pdf)

All forms, product invoice copies and documentation should be sent to the following address:

Inland Coatings Corporation
Warranty Department
P.O. Box 247
Adel, IA 50003